Installation Tips

1. Check the condition before installation!

You can connect all the parts, (including the extension cables, lenses, GPS, remote control, as well as your SD card) with the DVR, then using the USB cable for power supply (5V/1-2A), to see if the camera works normally. (please don’t us quick charger for power supply) If yes, then the camera is in good condition. If no, please contact with us for support: [e-mail] NOTE: please don't use phone quick charger for power supply. Since it may support both 5V and 9V charging, if it output 9V, the camera will be damaged.

2. Some suggestions on SD card

Since M1 records 1080P from both channel, it needs the SD card to has a high enough writing speed. Here is the tool and tutorial for testing the SD card to see if it is suitable to use with M1: click here

Then, let’s begin the installation!

3. Locate the lenses

Please remember to locate the lenses at a place with as little vibration as possible. * The reason is too much vibration will cause the “Rolling Shutter”, or called “Jelly Effect”. Can Google what it really is. But I can tell that the influence on the lenses is that the video recorded will be choppy.

4. Route the extension cable

There is no much point need to pay attention to, but keep it away from the hot part on your motorcycle. And don’t sandwiched the cable in crevice to avoid it from being pinched off.

Also remember to tighten the screw on the joint.

5. How to connect the connectors?

There is only one thing you need to pay attention to -- match the color of the connector.

And the green connector if for the front lens, the black connector is for the rear lens.

6. Locate the GPS

Please locate the GPS at an open space on your motorcycle to help it receiving the satellite signal.

* This GPS is different with the phone GPS function, since mobile phone uses both satellite signal and its communication service to get the location. But the GPS on M1 can only rely on the satellite signal. So that’s the reason why need it to locate at an open space.

** You need to synchronize the GPS data at first, then you can view your riding route on the App. Just feel free to contact us for tutorial, if you need our assistance.

7. Get power supply via the Voltage Converter or the USB cable

Just need to remember that the red cable on the converter should connect to the V+, and the black cable on the converter should connect to the V-.

And please make sure the motorcycle battery voltage is above 11.7V if you use the converter for power supply, since the converter has the “low voltage protection” feature to avoid the motorcycle battery from being exhausted.

8. Just feel free to contact us at any time for any question!

[e-mail]